Mother Day Special + Bang Bang

Products used:

- Glowdip starter set

- Colour: Mother Day Special

- Colour: Bang Bang

Step-by-step instructions for applying "Mother Day Special + Bang Bang " Dipping Powder

Materials:

• Mother Day Special Dipping Powder
• Bang Bang Dipping Powder
• Base coat
• Activator
• Top coat
• Nail file and buffer
• Dusting brush or soft brush

Preparation

File your nails into the desired shape and gently push back your cuticles.

For optimal adhesion, lightly roughen/match the natural nails with a buffer block or the fine side of a file before application.

Be sure to remove invisible cuticle and skin debris as well, to avoid lifting.

Do not apply oils or creams before use.

Step 1: Base coat

Apply a thin layer of Base Coat. The first coat should be quick and does not need to be too precise. Be careful not to paint the cuticles, as this can cause air bubbles under the nails and affect adhesion.

Dip your nail into "Mother Day Special" or "Bang Bang", a soft, warm shade perfect for a clean and feminine base. Hold your nail at a 90-degree angle while dipping to ensure even coverage, then gently tap off any excess powder. Use a soft brush to remove leftover particles around the cuticle and edges. Repeat this step for full opacity. Continue the same process for all nails—except the middle finger—using either “Mother Day Special” or “Bang Bang” as your main color.

For the middle finger, apply base coat only on one half of the nail—either straight down the middle for a vertical design or at a diagonal for a more dynamic look. Immediately dip this side into “Mother Day Special”. Once set, lightly brush away excess powder and carefully apply base coat to the other half of the nail. Dip this side into “Bang Bang” to create the half-and-half contrast.

Be sure to cover the edges well, but do not touch the skin around the nail.

Step 2: Base Coat & Color Powder

Repeat step 1 for optimal coverage, adhesion and beautiful and stunning color intensity.

Step 3: Activator Coat

Apply enough Activator Coat over the entire nail surface, edges and also at the tip. The Activator is the most important step in the application process because it seals and binds the layers to the nail, preventing air bubbles from forming and ensuring long-lasting adhesion. Allow the Activator Coat to dry for at least two minutes.

Step 4: Filing & Polishing

Now you can use the fine side of the file or a buffer to buff away all bumps and imperfections and bring the nails to the desired shape and thickness. It is important to file carefully so that you do not damage the surface and nails.

Step 5: Activator Coat

Repeat step 3. Again, apply enough Activator Coat to the entire nail and its perimeter to seal the layers optimally. Then allow the Activator Coat to dry for at least two minutes. To make sure the Activator Coat is dry, you can clean the surface of the nail with a paper towel after 2 minutes. This is to prevent the Top Coat from curing due to contamination.

Allow 2-3 minutes of waiting time between Top Coat and Activator Coat.

Step 6: Top Coat

Apply a thin layer of Top Coat evenly with 2-3 quick strokes and allow it to dry for at least two minutes.

Step 7: Top Coat

Repeat step 6. Apply a second, thin coat of Top Coat to the nails. Then let this dry for 2-3 minutes.

---

And voila! With these simple steps, you will create beautiful, long-lasting nails with the 'Mother Day Special + Bang Bang' dipping powder. Have fun with your beautiful nails!